Video guide

To see how to apply and remove sneakskin stickers, check out these video guides. The videos will show you the basic techniques you'll need to apply pre-cut stickers to your shoes. Watch it first and then, for more advanced tips and tricks, keep checking the blog for related posts.

• Watch the apply stickers video

• Watch the remove stickers video

Step 1:

Applying Stickers is really easy. All you need is the Sticker Sheet and a shoe.

Step 2:

Before you do anything, have a plan in mind or sketched out, how you’re going to customise the shoe and where to place the stickers.

Step 3:

Wash and dry your hands and shoes! If your hands or the shoes are not clean it could spoil everything as Sneakskin may not stick well if it gets dirty.

Step 4:

Decide which sticker you want to apply first and carefully peel it off the sheet. Better results may be achieved using a knife edge rather than a fingernail.

Step 5:

Carefully position one end of the sticker in place and smooth the remainder onto the shoe. You can peel it back and reapply it if you need to.

Step 6:

Job done, easy!

Step 1:

Unpick the edge or a corner of the sneakskin on the shoe. Peel it off very slowly and steadily. Try to pull the sneakskin at a sharp angle to avoid leaving glue residue on the shoe.

Step 2:

You probably wont need to clean your shoe (and the film will keep it nice and clean underneath). However, if some glue remains you can remove it by rubbing and rolling with clean fingers. When most of the residue is removed, you can finish up by rubbing the shoe very gently with a cleaning solution or a light solvent. For more useful tips on glue removal and how to avoid any damage to your shoe see our FAQ section.